| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758 |
- Samsung S5K5BAF UXGA 1/5" 2M CMOS Image Sensor with embedded SoC ISP
- --------------------------------------------------------------------
- Required properties:
- - compatible : "samsung,s5k5baf";
- - reg : I2C slave address of the sensor;
- - vdda-supply : analog power supply 2.8V (2.6V to 3.0V);
- - vddreg-supply : regulator input power supply 1.8V (1.7V to 1.9V)
- or 2.8V (2.6V to 3.0);
- - vddio-supply : I/O power supply 1.8V (1.65V to 1.95V)
- or 2.8V (2.5V to 3.1V);
- - stbyn-gpios : GPIO connected to STDBYN pin;
- - rstn-gpios : GPIO connected to RSTN pin;
- - clocks : list of phandle and clock specifier pairs
- according to common clock bindings for the
- clocks described in clock-names;
- - clock-names : should include "mclk" for the sensor's master clock;
- Optional properties:
- - clock-frequency : the frequency at which the "mclk" clock should be
- configured to operate, in Hz; if this property is not
- specified default 24 MHz value will be used.
- The device node should contain one 'port' child node with one child 'endpoint'
- node, according to the bindings defined in Documentation/devicetree/bindings/
- media/video-interfaces.txt. The following are properties specific to those
- nodes.
- endpoint node
- -------------
- - data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
- video-interfaces.txt. If present it should be <1> - the device
- supports only one data lane without re-mapping.
- Example:
- s5k5bafx@2d {
- compatible = "samsung,s5k5baf";
- reg = <0x2d>;
- vdda-supply = <&cam_io_en_reg>;
- vddreg-supply = <&vt_core_15v_reg>;
- vddio-supply = <&vtcam_reg>;
- stbyn-gpios = <&gpl2 0 1>;
- rstn-gpios = <&gpl2 1 1>;
- clock-names = "mclk";
- clocks = <&clock_cam 0>;
- clock-frequency = <24000000>;
- port {
- s5k5bafx_ep: endpoint {
- remote-endpoint = <&csis1_ep>;
- data-lanes = <1>;
- };
- };
- };
|
