| 1234567891011121314151617181920212223242526272829303132333435363738394041424344 |
- TPS62360 Voltage regulators
- Required properties:
- - compatible: Must be one of the following.
- "ti,tps62360"
- "ti,tps62361",
- "ti,tps62362",
- "ti,tps62363",
- - reg: I2C slave address
- Optional properties:
- - ti,enable-vout-discharge: Enable output discharge. This is boolean value.
- - ti,enable-pull-down: Enable pull down. This is boolean value.
- - ti,vsel0-gpio: GPIO for controlling VSEL0 line.
- If this property is missing, then assume that there is no GPIO
- for vsel0 control.
- - ti,vsel1-gpio: Gpio for controlling VSEL1 line.
- If this property is missing, then assume that there is no GPIO
- for vsel1 control.
- - ti,vsel0-state-high: Initial state of vsel0 input is high.
- If this property is missing, then assume the state as low (0).
- - ti,vsel1-state-high: Initial state of vsel1 input is high.
- If this property is missing, then assume the state as low (0).
- Any property defined as part of the core regulator binding, defined in
- regulator.txt, can also be used.
- Example:
- abc: tps62360 {
- compatible = "ti,tps62361";
- reg = <0x60>;
- regulator-name = "tps62361-vout";
- regulator-min-microvolt = <500000>;
- regulator-max-microvolt = <1500000>;
- regulator-boot-on
- ti,vsel0-gpio = <&gpio1 16 0>;
- ti,vsel1-gpio = <&gpio1 17 0>;
- ti,vsel0-state-high;
- ti,vsel1-state-high;
- ti,enable-pull-down;
- ti,enable-force-pwm;
- ti,enable-vout-discharge;
- };
|
