123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566 |
- * UART (Universal Asynchronous Receiver/Transmitter)
- Required properties:
- - compatible : one of:
- - "ns8250"
- - "ns16450"
- - "ns16550a"
- - "ns16550"
- - "ns16750"
- - "ns16850"
- - For Tegra20, must contain "nvidia,tegra20-uart"
- - For other Tegra, must contain '"nvidia,<chip>-uart",
- "nvidia,tegra20-uart"' where <chip> is tegra30, tegra114, tegra124,
- tegra132, or tegra210.
- - "nxp,lpc3220-uart"
- - "ralink,rt2880-uart"
- - "ibm,qpace-nwp-serial"
- - "altr,16550-FIFO32"
- - "altr,16550-FIFO64"
- - "altr,16550-FIFO128"
- - "fsl,16550-FIFO64"
- - "fsl,ns16550"
- - "serial" if the port type is unknown.
- - reg : offset and length of the register set for the device.
- - interrupts : should contain uart interrupt.
- - clock-frequency : the input clock frequency for the UART
- or
- clocks phandle to refer to the clk used as per Documentation/devicetree
- /bindings/clock/clock-bindings.txt
- Optional properties:
- - current-speed : the current active speed of the UART.
- - reg-offset : offset to apply to the mapbase from the start of the registers.
- - reg-shift : quantity to shift the register offsets by.
- - reg-io-width : the size (in bytes) of the IO accesses that should be
- performed on the device. There are some systems that require 32-bit
- accesses to the UART (e.g. TI davinci).
- - used-by-rtas : set to indicate that the port is in use by the OpenFirmware
- RTAS and should not be registered.
- - no-loopback-test: set to indicate that the port does not implements loopback
- test mode
- - fifo-size: the fifo size of the UART.
- - auto-flow-control: one way to enable automatic flow control support. The
- driver is allowed to detect support for the capability even without this
- property.
- Note:
- * fsl,ns16550:
- ------------
- Freescale DUART is very similar to the PC16552D (and to a
- pair of NS16550A), albeit with some nonstandard behavior such as
- erratum A-004737 (relating to incorrect BRK handling).
- Represents a single port that is compatible with the DUART found
- on many Freescale chips (examples include mpc8349, mpc8548,
- mpc8641d, p4080 and ls2085a).
- Example:
- uart@80230000 {
- compatible = "ns8250";
- reg = <0x80230000 0x100>;
- clock-frequency = <3686400>;
- interrupts = <10>;
- reg-shift = <2>;
- };
|