| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253 |
- modprobe sound
- insmod uart401
- insmod sb ...
- This loads the driver for the Sound Blaster and assorted clones. Cards that
- are covered by other drivers should not be using this driver.
- The Sound Blaster module takes the following arguments
- io I/O address of the Sound Blaster chip (0x220,0x240,0x260,0x280)
- irq IRQ of the Sound Blaster chip (5,7,9,10)
- dma 8-bit DMA channel for the Sound Blaster (0,1,3)
- dma16 16-bit DMA channel for SB16 and equivalent cards (5,6,7)
- mpu_io I/O for MPU chip if present (0x300,0x330)
- sm_games=1 Set if you have a Logitech soundman games
- acer=1 Set this to detect cards in some ACER notebooks
- mwave_bug=1 Set if you are trying to use this driver with mwave (see on)
- type Use this to specify a specific card type
- The following arguments are taken if ISAPnP support is compiled in
- isapnp=0 Set this to disable ISAPnP detection (use io=0xXXX etc. above)
- multiple=0 Set to disable detection of multiple Soundblaster cards.
- Consider it a bug if this option is needed, and send in a
- report.
- pnplegacy=1 Set this to be able to use a PnP card(s) along with a single
- non-PnP (legacy) card. Above options for io, irq, etc. are
- needed, and will apply only to the legacy card.
- reverse=1 Reverses the order of the search in the PnP table.
- uart401=1 Set to enable detection of mpu devices on some clones.
- isapnpjump=n Jumps to slot n in the driver's PnP table. Use the source,
- Luke.
- You may well want to load the opl3 driver for synth music on most SB and
- clone SB devices
- insmod opl3 io=0x388
- Using Mwave
- To make this driver work with Mwave you must set mwave_bug. You also need
- to warm boot from DOS/Windows with the required firmware loaded under this
- OS. IBM are being difficult about documenting how to load this firmware.
- Avance Logic ALS007
- This card is supported; see the separate file ALS007 for full details.
- Avance Logic ALS100
- This card is supported; setup should be as for a standard Sound Blaster 16.
- The driver will identify the audio device as a "Sound Blaster 16 (ALS-100)".
|
