| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778 |
- Background
- ==========
- Bulk endpoint streams were added in the USB 3.0 specification. Streams allow a
- device driver to overload a bulk endpoint so that multiple transfers can be
- queued at once.
- Streams are defined in sections 4.4.6.4 and 8.12.1.4 of the Universal Serial Bus
- 3.0 specification at http://www.usb.org/developers/docs/ The USB Attached SCSI
- Protocol, which uses streams to queue multiple SCSI commands, can be found on
- the T10 website (http://t10.org/).
- Device-side implications
- ========================
- Once a buffer has been queued to a stream ring, the device is notified (through
- an out-of-band mechanism on another endpoint) that data is ready for that stream
- ID. The device then tells the host which "stream" it wants to start. The host
- can also initiate a transfer on a stream without the device asking, but the
- device can refuse that transfer. Devices can switch between streams at any
- time.
- Driver implications
- ===================
- int usb_alloc_streams(struct usb_interface *interface,
- struct usb_host_endpoint **eps, unsigned int num_eps,
- unsigned int num_streams, gfp_t mem_flags);
- Device drivers will call this API to request that the host controller driver
- allocate memory so the driver can use up to num_streams stream IDs. They must
- pass an array of usb_host_endpoints that need to be setup with similar stream
- IDs. This is to ensure that a UASP driver will be able to use the same stream
- ID for the bulk IN and OUT endpoints used in a Bi-directional command sequence.
- The return value is an error condition (if one of the endpoints doesn't support
- streams, or the xHCI driver ran out of memory), or the number of streams the
- host controller allocated for this endpoint. The xHCI host controller hardware
- declares how many stream IDs it can support, and each bulk endpoint on a
- SuperSpeed device will say how many stream IDs it can handle. Therefore,
- drivers should be able to deal with being allocated less stream IDs than they
- requested.
- Do NOT call this function if you have URBs enqueued for any of the endpoints
- passed in as arguments. Do not call this function to request less than two
- streams.
- Drivers will only be allowed to call this API once for the same endpoint
- without calling usb_free_streams(). This is a simplification for the xHCI host
- controller driver, and may change in the future.
- Picking new Stream IDs to use
- ============================
- Stream ID 0 is reserved, and should not be used to communicate with devices. If
- usb_alloc_streams() returns with a value of N, you may use streams 1 though N.
- To queue an URB for a specific stream, set the urb->stream_id value. If the
- endpoint does not support streams, an error will be returned.
- Note that new API to choose the next stream ID will have to be added if the xHCI
- driver supports secondary stream IDs.
- Clean up
- ========
- If a driver wishes to stop using streams to communicate with the device, it
- should call
- void usb_free_streams(struct usb_interface *interface,
- struct usb_host_endpoint **eps, unsigned int num_eps,
- gfp_t mem_flags);
- All stream IDs will be deallocated when the driver releases the interface, to
- ensure that drivers that don't support streams will be able to use the endpoint.
|
