| 123456789101112131415161718192021222324252627282930313233343536373839 |
- #
- # HIPPI network device configuration
- #
- config HIPPI
- bool "HIPPI driver support"
- depends on INET && PCI
- ---help---
- HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and
- 1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI
- can run over copper (25m) or fiber (300m on multi-mode or 10km on
- single-mode). HIPPI networks are commonly used for clusters and to
- connect to super computers. If you are connected to a HIPPI network
- and have a HIPPI network card in your computer that you want to use
- under Linux, say Y here (you must also remember to enable the driver
- for your HIPPI card below). Most people will say N here.
- if HIPPI
- config ROADRUNNER
- tristate "Essential RoadRunner HIPPI PCI adapter support"
- depends on PCI
- ---help---
- Say Y here if this is your PCI HIPPI network card.
- To compile this driver as a module, choose M here: the module
- will be called rrunner. If unsure, say N.
- config ROADRUNNER_LARGE_RINGS
- bool "Use large TX/RX rings"
- depends on ROADRUNNER
- ---help---
- If you say Y here, the RoadRunner driver will preallocate up to 2 MB
- of additional memory to allow for fastest operation, both for
- transmitting and receiving. This memory cannot be used by any other
- kernel code or by user space programs. Say Y here only if you have
- the memory.
- endif # HIPPI
|
